Macquarie Semiconductor and Technology on behalf of Analog Devices, Inc.
Date of Manufacture: 08/2015
Currently Configured for: To be determined
Current Equipment Status: Available
Location of Equipment: Milpitas, United States
Available date: Currently Available
Chemwest DI(deionized water) Water Conductivity Control System
The Chemwest Conductivity Control System (CCS) has been designed to continuously adjust the amount of CO2 injected into an ultrapure water (UPW) stream to achieve the targeted conductivity. Changes in the UPW flow rate are not a problem for the CCS. Closed-loop control based upon conductivity is used to ensure the conductivity is maintained even as the flow rate changes rapidly.
The system uses membrane contactor technology to provide bubble-free injection of the CO2. An all fluoropolymer flow path is used to maintain the purity of the DI water and prevent the introduction of particles or contaminates.
The CCS operates in a wide range of UPW flow rates and conductivity levels providing the flexibility to meet an array of application requirements.
System flow range
1-60 L/min (1)
0.5 – 40 µS/cm2 (2)
± 5% of setpoint
Steady State Stability
± 2% of setpoint
(Dependent upon incoming UPW flow stability)
0.21 – 0.48 MPa (30-60 PSIG)
0.2 – 0.7 MPa (30-100 PSIG)
0.15 – 0.7 MPa (20-100 PSIG)
0.5 – 1.5 MPa (75-215 PSIG)
120 vac, 60 hz, 1 ph
FLA 5.1A, Max. 10A
Box Dimensions (Maximum; No Ftgs)
Height-57", Width-24", Depth-12"
1 Higher flow rate systems can be developed. Systems rated for >40L/min will be larger in dimension.
2 Conductivity range is dependent upon UPW flow range and temperature. Each system is shipped tuned for target conductivity setpoint and flow range. Please consult Chemwest for your specific requirements.
3 System requires a minimum of 200mm (8") above and 200mm (8") below the unit to allow facility connections.
The information referenced on this page is accurate to the best of our knowledge. We do not warrant the completeness or accuracy of the information contained herein. Interested parties are encouraged to request inspection to verify equipment condition, configuration, and completeness. Any offer to purchase equipment shall be subject to our standard terms and conditions of sale.
Get in touch
Ask about our equipment solutions, ranging from Macquarie equipment inventory sales, sourcing programs, surplus disposition options, and direct equipment purchases.